surfloha.blogg.se - Does 8bit fiesta take other controllers

#DOES 8BIT FIESTA TAKE OTHER CONTROLLERS UPDATE#

Since you can use SD-Card with size up to 32GB, it's no problem to store up to 20 hours of high quality laser show on one card. You can also set all the required properties of drawing - size, position, rotation, brightness, scan-rate, animation speed, color. Using DMX you can switch among the animations. You can store up to 254 different animations or even complete laser shows on your SD-Card. In Ethernet mode Moncha.NET allows you to control also DMX devices. Remotely you can also setup stand alone mode, define brightness map or control color balance and color fade curves. Since SD-Card uses standard FAT32 file system, you can use any cheap card reader to do that.īut Moncha.NET comes with great possibility to upload animations or shows directly from software. You can also create laser show effects or complete laser shows and save them to Moncha.NET's SD-Card.

While you create graphics or shows, you'll be able to preview all your work on your laser system, even using wireless Wi-Fi signal. You can control Moncha.NET device in real time e.g. Remote control over Ethernet or even Internet (public IP address required) - upload frames and shows, configure stand-alone mode, configure brightness map and color optimization.Color optimization - color balance and fade curves on SD-card (works in DMX or Stand-alone mode).Laser safety - brightness map works also in DMX or Stand-alone mode.You can store up to 20 hours of laser show on one SD-card.You can use any SD-card reader to change the contents of card.Uses standard SD-card with size up to 32GB to store up to 254 complete laser shows.40kpps maximal scan rate is good even for graphics shows.Possibility to add special board with display: external ILDA, safety key support, X and Y invert integrated.

Three ways to control: Ethernet, DMX, Stand-alone.

It also saves lot of time and special boards for laser system producers - there is external ILDA, safety keyand X, Y invert integrated. It allows you to control your Moncha.NET using display and directional keys. We provide also additional board for Moncha.NET. It's working completely over Ethernet in real time, or it is even possible to control it over DMX or in stand-alone mode. Thanks to small size, it is a perfect OEM controller even for low-cost laser show systems. The remaining Moncha.NET devices can be slaves (=not activated to Master). Need only one (!) Moncha.NET Master device to create laser shows for more laser

#DOES 8BIT FIESTA TAKE OTHER CONTROLLERS UPDATE#

Update for your Moncha.NET device, which allows you to run Fiesta software.